Table of Contents
Advertisement
Chapter 5: Installing the Switch on a Wall
Installing the Switch on a Concrete Wall
66
This section contains the instructions for installing the switch on a
concrete wall. Please review the information in the following sections
before performing the procedure:
"Switch Orientations on a Wall" on page 58
"Installation Guidelines" on page 59
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
E105
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. Install the four wall/equipment rack brackets to the sides of the unit
with the sixteen M4x6mm screws included with the switch. Refer to
Figure 26 on page 64.
3. Have another people hold the switch on the concrete wall at the
selected location for the device while you use a pencil or pen to mark
the wall with the locations of the four screw holes in the four brackets
(one screw per bracket). Refer to Figure 28 on page 67.
Please follow these guidelines as you position the switch on the wall:
Position the switch so that the front panel is either on the left or the
right. Refer to Figure 23 on page 58. You may not install the switch
with the front panel facing up or down.
Leave sufficient space from other devices or walls so that you can
access the front and back panels, and for adequate air ventilation.
Advertisement
Table of Contents
