Table of Contents
Advertisement
Chapter 3: Installing the Switch on a Table or Desktop
48
5. Install the bumper feet as follows:
a. Inset a rivet housing into a bumper foot. Refer to Figure 15.
Figure 15. Inset the Rivet Housing into the Bumper Foot
b. Place the bumper foot on one of the corner holes in the base of the
switch. Refer to Figure 16.
Figure 16. Place the Bumper Foot on a Base Corner Hole
c. Insert the rivet to secure the bumper foot to the base. Refer to
Figure 17 on page 49.
Advertisement
Table of Contents
