Calendar (Calendar) - ABB i-bus KNX ABA/S 1.2.1 Product Manual

®
ABB i-bus KNX
Parameters
7.10.29

Calendar (CALENDAR)

Description
Used for events that occur periodically or on specific dates. A wide variety of settings is possible.
The calendar uses the logic controller's internal clock. It can be changed via the bus (group objects).
The output value is 1 if the device time is between Start and End and the other conditions are met.
Inputs
No.
1
2
3
4
5-7
8
9
76 2CDC509086D0201 | ABA/S 1.2.1
DPT Abbr. Name
Time S Start
Time E End
1 bit A Active
Whole
1 bit WT
time
Date B Begin
Date U Until
Visible Description
Defines the start time;
Parametrizable
refers to corresponding parameters
Defines the end time;
Parametrizable
refers to corresponding parameters
If Active = 0 the output is always 0;
Parametrizable
refers to corresponding parameters
If Whole time = 1, Start = 00:00:00 and
End = 24:00:00;
Parametrizable
refers to corresponding parameters
Recurrence (Daily, Weekly, Monthly, Yearly);
see below
Defines the date for activation of the Calendar
element (sets a duration);
Parametrizable
before this date, the output value is 0;
refers to corresponding parameters
Defines the date for deactivation of the
Calendar element (sets a duration);
Parametrizable
before this date, the output value is 0;
refers to corresponding parameters