Table of Contents
Advertisement
Inserting and Removing an SD Card
1 Turn off the camcorder.
• Make sure the POWER/CHG indicator is off.
2 Open the card compartment cover.
• Slide the SD CARD switch all the way in the direction of the
arrow to open the cover.
3 Insert the card straight, with the label facing the grip belt
side of the camcorder all the way into one of the card
slots until it clicks.
• You can use two cards, one in each card slot.
• To remove a card, make sure the ACCESS indicator is off and
then push the card once to release it. When the card springs
out, pull it all the way out.
4 Close the card compartment cover.
• Do not force the cover closed if the card is not correctly
inserted.
ACCESS (card access) indicator
SD card access indicator
Red (on or flashing)
Accessing the card(s).
Neither card is being accessed or no cards are inserted in
Off
the camcorder.
> [
System Setup] > [ACCESS LED] to [j Off], the ACCESS indicator will not illuminate.
If you set
IMPORTANT
• Turn off the camcorder before inserting or removing a card. Inserting or removing a card with the camcorder
on may result in permanent data loss.
• SD cards have front and back sides that are not interchangeable. Inserting a card facing the wrong direction
can cause a malfunction of the camcorder. Be sure to insert the card as described in step 3.
NOTES
• SD cards have a physical switch to prevent writing on the card so as to avoid the accidental erasure of the
card's content. To write-protect the SD card, set the switch to the LOCK or C position.
Initializing an SD Card
Initialize SD cards when you use them with this camcorder for the first time. You can also initialize a card to
permanently delete all the recordings it contains.
Operating modes:
1 Select [Initialize] for the desired SD card.
> [3 " Recording Setup] > [Initialize 8] > [6 Mem. Card A] or [7 Mem. Card B] > [Initialize]
2 Select [Yes].
3 When the confirmation message appears, select [OK] and then [X].
Card status
Using SD Cards
33
Advertisement
Table of Contents
