Canon XA50 Instruction Manual page 120

Menu Options
Menu item
[Speaker Volume]
[Monitor Channels]
120
[HDMI Channels]
[Notification Sounds]
[£ Display Setup] menu
Menu item
u
[Output Terminal]
[HDMI Max Resolution]
u
[SDI Output]
u
[3G-SDI Mapping]
u
[SDI/HDMI Scan Mode]
v
[HDMI Scan Mode]
[Output Status]
[LCD Brightness]
[LCD Backlight]
[Viewfinder Backlight]
[LCD Mirror Image]
[Output Onscreen Displays]
[Onscreen Markers]
Setting options and additional information
Volume adjustment bar: 0 to 15 (8), [Ø] (softer), [Ù] (louder)
In mode only, this setting is an alternative way to adjust the built-in speaker's volume (A 99).
[ƒ CH1/CH2], [š CH1/CH1], [Ÿ CH2/CH2], [
[ CH3/CH4], [ CH3/CH3], [
[ CH1+3/CH2+4]
[ƒ CH1/CH2], [ CH3/CH4]
[ High Volume], [ Low Volume], [j Off]
A beep will accompany some of the camcorder's operations.
• While pre-recording is activated, the camcorder will not emit any notification sounds.
Setting options and additional information
[ø SDI], [ù HDMI]
[3840x2160]*, [1920x1080], [1280x720(59.94P)]
* Available only in mode.
[1920x1080], [1280x720(59.94P)]
[ Level A], [ Level B]
[ P], [ PsF (Forced 1080i)]
—
Displays a screen where you can check the configuration (video and audio) of the output signal.
Brightness adjustment bar, [ ] (darker), [
• Changing the brightness of the screen does not affect the brightness of your recordings or the
brightness of the playback image on a TV.
[ Bright], [ Normal], [
[ Bright], [ Normal]
Changes the screen's backlight level to one of three levels (LCD screen) or two levels (viewfinder),
affecting the general brightness of the screen.
• Changing the brightness of the screen does not affect the brightness of your recordings or the
brightness of the playback image on a TV.
[i On], [j Off]
When this setting is set to [i On], this function reverses the image on the screen horizontally
when you rotate the LCD panel 180 degrees toward the subject. In other words, the screen will show
a mirror image of the subject.
• If the camcorder is operated (touch screen, physical buttons and switches, or remote operation)
while the mirror image is displayed, the normal image will be displayed temporarily. After about
4 seconds, the mirror image is displayed again.
[i On], [j Off]
When this setting is set to [i On], the camcorder's onscreen displays will appear also on the
screen of a TV or monitor connected to the camcorder.
[j Off], [4 Level (Gray)], [3 Level (White)], [6 Grid (Gray)],
[5 Grid (White)]
You can display a grid or a horizontal line at the center of the screen. Use the markers as a reference
to make sure your subject is framed correctly (vertically and/or horizontally).
• Using the onscreen markers will not affect the recordings.
CH1+2/CH1+2],
CH4/CH4], [ CH3+4/CH3+4],
] (brighter)
Dim]
(A 110)
(A 111)
(A 107, 108)
(A 108)
(A 107)
(A 107)
(A 109)