Image Stabilization; Dynamic Is Or Standard Is; Powered Is - Canon XA50 Instruction Manual

Image Stabilization

Image Stabilization
Use the image stabilizer to compensate for camcorder shake in order to achieve steadier shots. The camcorder
offers the following IS modes.
60
Standard IS (¯): Standard IS compensates for a lower degree of camcorder shake, for example, for handheld
shots while you remain stationary, and is suitable for shooting natural-looking scenes.
Dynamic IS (°): Dynamic IS compensates for a higher degree of camcorder shake, such as when shooting
while walking, and is more effective as the zoom approaches full wide angle.
Powered IS (±): Powered IS is most effective when you are stationary and zooming in on far subjects using
high zoom ratios (the more you approach the telephoto end). This mode is not suitable for tilting and panning
shots.
Operating modes:

Dynamic IS or Standard IS

1 Select [Image Stabilizer].
> [v $ Camera Setup] > [Image Stabilizer]
2 Select [¯ Standard] (Standard IS) or [° Dynamic] (Dynamic IS) and then select [X].
• Select [® Off] instead to turn off the image stabilization, for example, when the camcorder is mounted on
a tripod.
• The icon of the selected mode appears at the top of the screen.

Powered IS

Press and hold the POWERED IS button as long as you want to
activate Powered IS.
• ± appears in yellow at the top of the screen while Powered IS is
activated.