Example Of Pve Use - Danfoss PVE Series 4 Technical Information

Technical Information
PVE control
32
PVE, Series 4 for PVG 32/100/120 and PVHC
PVES Series 4
The PVES has an ASIC closed loop
circuit and the NC-S solenoids.
PVE hysteresis overview
PVE S
Maximum 2 %
Typical <½ %
•
PVEP has the PVES characteristic.
•
PVEU is available with both standard PVEH and super fine PVES characteristic.
•
PVHC has hysteresis like PVEM at fixed temperature and viscosity. (For PVHC temperature and
viscosity shifts control signal effect.)

Example of PVE use

Signal leads must not act as supply leads at the same time unless the distance between the actuator
module PVE and terminal board is less than 3 m [3.3 yards] and the lead cross-section is min. 0.75 mm
[AWG 18].
520L0553 • Rev GD • Jan 2014
PVEA Series 4
The PVEA has an ASIC closed loop
circuit, standard NC solenoids
and orifice instead of NO
solenoids.
C
Caution
PVEA is not for use on PVG 100.
A
6 %
2 %
PVEH Series 4
The PVEH has an ASIC closed
loop circuit and the standard NC
solenoids.
H M
6 % 35 %
4 % 25 %
2