Setting Up Ip Via Firmware Commands; Wi-Fi Connection; Select One Communication; Device State And Ui - ID Tech ViVOpay VP6800 User Manual

8.6.2 Setting Up IP via Firmware Commands

To use firmware commands to set up IP configuration, refer to the NEO II Serial Interface
Developer's Guide.

8.7 Wi-Fi Connection

Make sure to configure Wi-Fi before using wirelessly connecting with the host. To set up Wi-Fi
parameters, refer to the NEO II Serial Interface Developer's Guide.

8.8 Select One Communication

The VP6800 is not designed to use Wi-Fi, Bluetooth, and Ethernet at the same time. Make sure to
first select the desired interface via the appropriate firmware command before attempting
communication. For detailed information, refer to the NEO II Serial Interface Developer's Guide.

8.8.1 Device State and UI

State Beep
De-activated Short beep
for 5 seconds
Activated No Beeper
LCD Indicating
"Deactivated" Device is in "Manufactory mode;" no
security functions enabled.
"Activated" Manufactory data and certificate loaded
into device, but no working keys.
Page | 13