Connecting Cable And Power; Activate Removal Sensor; Sending An Activate Removal Sensor Request From The Usdk Demo - ID Tech ViVOpay VP6800 User Manual

8.3 Connecting Cable and Power

1. When developing for the VP6800, connect the power supply to the RS-232 interface.
2. Connect the RS-233 interface to PC serial port.
Or connect Ethernet interface.
3. Connect the +5VDC power supply to the barrel receptacle on the RS-232 cable. Plug the
unit into an AC outlet and verify that the VP6800 lights up.

8.4 Activate Removal Sensor

After installing the device to a vendor machine, activate the removal detection function when the
unit starts up. Otherwise, the device will prevent Get PIN or Get MSR operations.

8.4.1 Sending an activate removal sensor request from the USDK Demo

The removal detection function can be activated by entering the correct command and the user
passwords from two different users in the USDK demo. Make sure to have
installed the USDK Demo prior starting the process.
1. Enter an activate removal detection command in the USDK Demo and click Execute
Command.
downloaded and
Page | 11