Service Information - HAKO Scrubmaster B175 R Operating Manual

Operation
3.6

Service information

In case problems occur with the machine, a four-digit service code is output in
the display panel in addition to the service indicator (tool key).
Eliminate the cause or note down the service code and inform your authorised
Hako service partner.
If the cause has been eliminated, the fault must be acknowledged via the key
switch OFF/ON.
Service Fault
code
1.2.2.1 Brushes/
Roller stop
1.2.5.1/ Brushes stop
1.2.5.2
1.2.6.1/ Brushes stop
1.2.6.8
1.2.6.3 Brush lift sys-
tem, brush
and suction
turbine have
been switched
off
1.4.6.1 Squeegee lift
system stops
1.4.6.3/ Suction tur-
1.4.6.4 bine stops
58
Cause
Electrical defects
Foreign particles
between brush and
shaft
Foreign particles
block the brush
Brush not positioned
correctly in the holder
Foreign particles
between brush head
and machine
Brush head stuck
Overload due to for-
eign particles
Foreign particles
between squeegee
and machine
Squeegee jammed
Foreign particles in
the suction turbine
Faulty suction turbine
Remedy
Notify service partner
Inspect the brushes for for-
eign particles and remove
them if necessary
Inspect the brushes for for-
eign particles and remove
them if necessary
Actuate the brush decou-
pling system, contact
the service partner, if
necessary
Inspect the brush head for
foreign particles and
remove them if necessary
Release brush head
Inspect for foreign particles
and remove them if
necessary
Inspect the lift system for
foreign particles and
remove them if necessary
Make the squeegee
accessible
Notify service partner
03-7180-00.fm