Note: As the voltage source is only a single channel, the hold voltage will be the same
9.6 Stabilised Current Output Settings
9.6.1 Measurement Settings
(I)
Voltage
•
Set the voltage to apply to the sample for the measurement.
I. This can be set between -10 V and +10 V.
(II)
Total Time
•
Set the total length of the measurement in minutes.
(III)
Time Interval
•
Set the time between each current measurement in seconds.
I. This has a minimum of 0.1 seconds.
9.7 Saving and Loading Settings
20
for all pixels being tested.
Figure 9.10. Experimental Parameters settings for the Stabilised Current Output.
Figure 9.11. Controls for saving and loading settings profiles.