Quickstart Guide - Ossila Solar Cell I-V Test System User Manual

9.1.3 Stabilised Current Output
The Stabilised Current Output tab lets you measure the evolution of the photogenerated current at
specific voltages.

9.2 Quickstart Guide

Start the Ossila Solar Cell I-V software. The window shown in Figure 9.1 will open.
1.
Choose a measurement type as described in Section 9.1.
2.
3. Place your sample in the test board.
4. Place the test board beneath your solar simulator.
5. Set the appropriate settings in the software (explained in more detail in Sections 9.4 - 9.8).
I. Set 'Pixel Switching' to 'Automated'.
6. Open the shutter of your solar simulator.
7. Click the 'Measure' button.
I. For each pixel, measurements are performed using the chosen measurement settings.
II. After the measurement has completed, the results are displayed in the central plot.
III. This process is repeated until all pixels have been measured.
8. If automatic saving is turned on, the measurement data and settings will then be saved.
14
Figure 9.3. Solar Cell I-V software: The Stabilised Current Output tab.