9.3 Shared Software Settings
The settings in these sections are shared between all measurement types.
9.3.1 Connection
(I)
Connection Type
•
Select the type of connection you are using (either USB or Ethernet).
I. Any connected units will be automatically detected when a selection is made and the 'System
Address' box will be populated.
•
The software will search for units connected via USB on start-up.
I. To rescan for connected units (in case the connection is changed), click the refresh icon next to
the 'System Address' box.
(II)
System Address
•
Select the COM port or IP address of the connected unit you intend to use (USB and Ethernet
connection respectively).
I. This box will be populated automatically with the addresses of any units connected to the
computer via the method selected in the 'Connection Type' box.
9.3.2 System Settings
(I)
Voltage Source
•
'SMU 1' will be automatically selected when pixel switching is set to 'Automated'.
Figure 9.4. Connection settings.
Figure 9.5. System settings.
15