Solar Cell Characterisation Settings - Ossila Solar Cell I-V Test System User Manual

(III) Pixel Area
• Set the are in cm
(IV) Inverted Device
• Set whether the device to be measured is inverted.
I. This option should be on if the anode of your device connects to the 'cathode' pins in the
device holder.

9.4 Solar Cell Characterisation Settings

9.4.1 Measurement Settings
(I) Start Voltage
• Set the voltage in volts at which to start the current-voltage measurement.
I. This can be set between -10 V and +10 V.
(II) End Voltage
• Set the voltage in volts at which to end the current-voltage measurement.
I. This can be set between -10 V and +10 V.
(III) Voltage Increment
• Set the step size in volts for changing the voltage during current-voltage measurement.
of each pixel in the device.
2
Figure 9.7. Measurement Settings for the solar characterisation.
17