S1 Dip Switch - Siemens SINAMICS S120 System Manual

8.3.5

S1 DIP switch

Table 8- 5 DIP switch S1
Terminal
1
2
It is only permissible to changeover when in the no-voltage state.
Figure 8-2 DIP switch on the upper side of the component
When delivered, "single operation" is set. Both switches are set to the left.
High Frequency Drive
System Manual, (SH2), 04/2015, 6SL3097-4AH10-0BP3
Designation
Changeover switch, single
operation / parallel operation
Dummy contact
(not used)
Technical data
Left: Single operation
Right: Parallel operation
Changing over the output characteristic
Control Supply Module (CSM)
8.3 Interface description
133