REMKO ATK 25 Operation, Technology And Spare Parts

REMKO ATK 25 Operation, Technology And Spare Parts

Automatik oil heater

Advertisement

REMKO ATK 25
Automatic oil heater
Operation
Technology

Spare Parts

REMKO - powerful like a bear.
Edition GB – R01

Advertisement

Table of Contents
loading

Summary of Contents for REMKO ATK 25

  • Page 1: Spare Parts

    REMKO ATK 25 Automatic oil heater Operation Technology Spare Parts REMKO - powerful like a bear. Edition GB – R01...
  • Page 3: Table Of Contents

    Our guarantee will become void when the unit supplied by us is used and installed for inadequate purposes, or maintained incorrectly, etc., or if it is changed without our prior consent. Subject to alterations! Automatic oil heater REMKO ATK 25 Contents Contents Page Page...
  • Page 4: Safety Instructions

    Safety Instructions Description of Device Please make sure that the relevant local building The unit is fired directly with heating oil EL or diesel and and fire protection codes as well as the regulations can be operated with or without an exhaust-gas con- of the employer's liability insurance associations nection.
  • Page 5: Provision Of Air Heaters

    Safety temperature limiter (STB) The STB interrupts the supply of fuel if the unit over- openings which are not lockable are present in the heats and causes the automatic burner relay to switch region of ceiling and floor for the air supply and for off.
  • Page 6: Installation Requirements

    Installation Requirements Exhaust system The heaters may only be installed in compliance with In the outdoors or in open rooms, the operation of the the relevant regulations, in particular, regulations gov- device is also possible without an exhaust system. erning the installation and operation of fireplaces and However, we recommend a 1 m exhaust-pipe (see ex- furnaces.
  • Page 7: Starting

    Starting Connect the unit with the current supply Prior to starting, the unit is to be checked to make sure 1. Put operating switch 1 into “0” position (OFF). that there are no visible defects on the control and safety devices, that the unit has been installed correctly 2.
  • Page 8: Maintenance And Service

    Maintenance and Service Cleaning the burner The unit is to be maintained regularly whereby some Clean the components of the burner as described be- low: fundamental rules are to be observed to ensure a long service life and trouble-free operation. 1.
  • Page 9: Exhaust Measurement

    “guarantee certificate” enclosed with 7. Start unit and let it run for approx. 3 minutes. all heating units and send it back to REMKO GmbH & Co. KG in a timely manner after purchasing of the unit After maintenance work is complete, conduct an and putting it into operation.
  • Page 10: Fuel Pump

    Fuel Pump Technical Data The standard type of the pump runs in a system of Model ATK 25 1 pipe. The required fuel is sucked in through the suction Nominal heat output max. 25,00 line "S". Nominal heat output 22,50...
  • Page 11: Troubleshooting

    Troubleshooting Trouble: Cause: 2 – 3 – 4 – 6 – 7 – 8 – 25 motor does not start motor is running but burner will not be ignited 1 – 5 – 6 – 9 – 10 – 11 – 12 – 13 – 14 – 15 – 16 – 17 20 –...
  • Page 12: Exploded View

    Exploded View Fig. A Abb. “A” 23 24 See fig. A Siehe Abb. “A” We reserve the right to make modifications in dimensions and construction in the interests of technical progress.
  • Page 13: Spare Part List

    For the guarantee to be valid, the customer must completely fill out the “guarantee certificate” enclosed with all heating units and send it back to REMKO GmbH & Co. KG in a timely manner after purchasing of the unit and putting it into operation.
  • Page 14: Maintenance Log

    Maintenance Log Model : ........ Model No. : ........9 10 11 12 13 14 15 16 17 18 19 20 Clean unit -surface- Clean unit -interior- Clean fan Clean combustion chamber Clean burner head Adjust ignition electrode Replace nozzle Clean / replace fuel filter Adjust / measuring burner Check safety facility...
  • Page 16 REMKO GmbH & Co. KG Klima- und Wärmetechnik D-32791 Lage Im Seelenkamp 12 • D-32777 Lage PO Box 1827 • Phone +49 5232 606 - 0 +49 5232 606 260 E-Mail info@remko.de Internet www.remko.de...

Table of Contents