Subscribe to Our Youtube Channel
Related Manuals for REMKO VRS Series
Summary of Contents for REMKO VRS Series
- Page 1 REMKO VRS Universal oil/gas automatic heaters Operation Technology Spare Parts Edition GB – M10 REMKO – powerful like a bear.
-
Page 3: Table Of Contents
Our guarantee becomes null and void if the unit is used, set up or maintained improperly, or if modifications are made to the supplied unit without our prior consent. Subject to alterations! Stationary Warm Air Heating Systems REMKO VRS Contents Contents Page Page... -
Page 4: Safety Instructions
◊ The units must be set up outside of traffic zones, e.g. away from cranes. REMKO automatic heaters supply heat or regulate the A safety zone of 1 m is to be maintained around the temperature of: units. -
Page 5: Prior To Assembly
Prior to Assembly Operation After switching on the unit by setting the operating When setting up the units, the relevant regional building switch to “Heizen” (heating), the forced-air burner turns and fire protection codes of the respective region must on automatically. The combustion chamber with heat- be observed. - Page 6 Important Information about Safe Setup Air Supply for Combustion ◊ The units may only be set up and operated in rooms An adequate supply of air for combustion must be en- sured by meeting the relevant building requirements. where there is enough air for combustion and the ex- pelled air is guided to the outside via an exhaust sys- Excerpts from the German fire ordinance: tem.
-
Page 7: Setup And Assembly
Fuel Supply Wall Assembly Particularly for heating oil lines, make sure that the The wall where the unit is to be assembled may not be cross-section of the lines corresponds to the suction made of flammable materials. Its load-bearing capacity height, the total line resistance and increased viscosity must be tested and, if necessary, reinforced. - Page 8 Gas Connection Depending on the capacity of the unit, the required The thermostat sensor may not be exposed directly to a quantity of gas must always be available and the neces- particularly cold or warm air current. sary gas pressure present during unit operation. The process is the same for installation of an automatic Gas pressure regulators and shut-off valves are to be day/night temperature regulator (accessory).
- Page 9 Under certain circumstances, it is possible to meas- console ure the exhaust opening. The double-walled, REMKO stainless steel exhaust sys- Make sure to maintain a safe distance to flamma- tems have been approved by the Institut für Bautechnik ble materials! (German Institute for Construction Engineering) in ac- cordance with DIN 18160 Part 1.
-
Page 10: Prior To Initial Operation Of The 400 V Series
Prior to Initial Operation Before Starting of the 400 V Series Initial operation of the unit and its forced-air burner must be performed by the manufacturer or one of its author- Fan Motor Operation ised service representatives. During this process, all regulating, control and safety Check the drive. -
Page 11: Starting
Starting Maintenance and Service The operator must have the unit checked and serviced Heating Mode as necessary, at least once a year, by a representative 1. Turn the customer-supplied main switch or the fuse of the manufacturing company or another authorised in- dividual in accordance with the operating conditions. - Page 12 A special boiler cleaning set for the REMKO industrial A special boiler cleaning set for the REMKO indus- vacuum cleaner can be purchased as an accessory. trial vacuum cleaner can be purchased as an acces- 8.
-
Page 13: Troubleshooting
“guarantee certificate” enclosed with ◊ Check that there is enough fuel in the fuel container. all heating units and send it back to REMKO GmbH & ◊ Check whether paraffin has accumulated in the heat- Co. KG in a timely manner after purchasing of the unit and putting it into operation. -
Page 14: Technical Data Vrs Inox
Technical Data VRS INOX REMKO VRS 1 0 0 1 3 0 1 7 0 2 0 0 Rated heat power Rated heat output 16,7 Rated air output m³/h 1.050 1.760 3.950 5.270 7.950 9.800 12.000 13.900 Rated pressure, external... -
Page 15: Technical Data Vrs B
Technical Data VRS B REMKO VRS Rated heat power Rated heat output 3.400 4.650 6.800 9.750 11.700 15.700 19.300 23.600 29.500 35.200 Rated air output m³/h Rated pressure, external Fuel H e a t i n g o i l... -
Page 16: Technical Data Vrs B
Technical Data VRS B Electric motor(s) Ventilator(en) V-belt discs Sound Rated REMKO pressure Rated Rated Rated pressure Electrical Rated level power con- engine Model engine Model Motor ∆ ext. connection current sumption speed speed pA 1m V / Hz ø mm ø... -
Page 17: Wiring Diagram Vrs 20 Inox
Wiring Diagram VRS 20 INOX Fan motor: 230 V / 1~ Burner motor: 230 V / 1~ Capacitor (fan) Control lamp GREEN (operation) Control lamp RED (burner malfunction) Terminal strip power input An easily accessible emergency switch must be at- tached in the setup room, but not close to hazardous Terminal strip electrical wiring areas. -
Page 18: Wiring Diagram 230 V
Wieland plug from the control box Wieland socket from the burner Capacitor REMKO Triple Combination Control An easily accessible emergency switch must be at- tached in the setup room, but not close to hazardous Terminal strip in the control box areas. -
Page 19: Wiring Diagram 400 V Direct Start
H4 Malfunction lamp (burner) tached in the setup room, but not close to hazardous Fan contactor areas. KB REMKO triple combination control This switch must be protected from damage and un- authorised use! Fan motor RT1 Room thermostat day (accessory) -
Page 20: Wiring Diagram 400 V ∆ / Y Start
Wiring Diagram 400 V ∆ / Y - Start Fan motor: 400 V / 3~ Burner motor: 230 V / 1~ Burner plug opt. Running hour meter white white Terminal strips in the control box numbered burner cable *) During the thermostat connection: Remove bridge We reserve the right to make modifications in dimensions and construction in the interests of technical progress. -
Page 21: Wiring Diagram Fan Motor
Operating lamp (fan) areas. Malfunction lamp (fan) This switch must be protected from damage and un- REMKO triple combination control authorised use! Contactor for ∆ / Y switch The electrical connections should only be made by authorised personnel. -
Page 22: Exploded View Vrs 20 Inox
Exploded View VRS 20 INOX We reserve the right to make modifications in dimensions and construction in the interests of technical progress. -
Page 23: Spare Part List Vrs 20 Inox
Spare Part List VRS 20 INOX Description Ref. No. Blow-out cover, cpl. (without blow-out grille) 359169 Blow-out grille (front) 1095343 Lining plate, left/right 1103140 Insulation, left/right 1103141 Insulation, front 1103142 Lining plate, front 1103143 Air suction grille, left/right 1103144 Lining plate, top/bottom 1103145 Safety temperature limiter, STB 1101197... -
Page 24: Exploded View Vrs Inox
Exploded View VRS INOX Fig. VRS 50 Fig. Fan with belt operation Replacement for No. 6 for design size 130 and higher We reserve the right to make modifications in dimensions and construction in the interests of technical progress. -
Page 25: Spare Part List Vrs Inox
Spare Part List VRS INOX 25 Inox 50 Inox 75 Inox 100 Inox 130 Inox 170 Inox 200 Inox No. Description Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Unit frame, cpl. 1103200 1103201 1103202 1103203 1103204... -
Page 26: Exploded View Vrs B
Exploded View VRS B 25 a/b Fig. VRS 80 upright model We reserve the right to make modifications in dimensions and construction in the interests of technical progress. -
Page 27: Spare Part List Vrs B
Spare Part List VRS B VRS 40 VRS 60 VRS 80 VRS 120 VRS 150 VRS 210 VRS 250 VRS 310 VRS 380 VRS 450 No. Description Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Ref. No. Ref. -
Page 28: Unit Dimensions Vrs Inox
Unit Dimensions VRS INOX Standing Unit ø R Unit on its side Unit type VRS 20 I VRS 25 I VRS 50 I VRS 75 I VRS 100 I VRS 130 I VRS 170 I VRS 200 I (dimensions in mm) 1000 1250 1250... - Page 29 Unit Dimensions VRS B Standing Unit Unit on its side Unit type VRS 40 VRS 60 VRS 80 VRS 120 VRS 150 VRS 210 VRS 250 VRS 310 VRS 380 VRS 450 (dimensions in mm) 1055 1284 1284 1514 1667 1667 1860 1860...
- Page 30 Maintenance Log Model: : ........ Model No.: : ........Burner : ........ Burner No.: : ........9 10 11 12 13 14 15 16 17 18 19 20 Clean unit -surface- Clean unit -interior- Clean fan Clean combustion chamber Clean heat exchanger Clean/replace waste gas suppressor Replace seals -inspection cover- Replace seals –burner-...
- Page 32 REMKO GmbH & Co. KG Klima- und Wärmetechnik D-32791 Lage Im Seelenkamp 12 • D-32777 Lage PO Box 1827 • Phone +49 (5232) 606 - 0 +49 (5232) 606260...
Need help?
Do you have a question about the VRS Series and is the answer not in the manual?
Questions and answers