Alteration Of Shelf Configuration To Convert Single Space Cells Into L½ Width Cells; Additional Accessories - Unicum FOODBOX User Manual

ТМ
Fig.41 - Shelf with double width cells
ATTENTION! This test assumes the dispensing of product from the tested cell
into the dispenser tray. If this would not happen following a complete turn of the
motor, the spiral will be rotated completely and the test will end with "FAILURE"
notice.
4.6.2.2 Alteration of shelf configuration to convert single space cells into l½ width cells
Figure 42 shows the overall view of the shelf with 1½ space cells for selling medium width products.
Fig.42 - Shelf with 1½ width cells

4.6.2.3 Additional accessories

Fig.43 - Spacers
Version 3.4 / November 2016
FOODBOX / FOODBOX LONG
After changing the shelf configuration it is important to test the
operational status of the motors. For the purpose enter Opera-
tor's menu and select menu item SNACK/MOTOR TEST (input
cell number) – see section MAiNTENANCE MODE.
• Remove two spacers (see fig 38 position 1);
• Disconnect and remove two motors with spirals (see fig 38,
position 2) – see section 4.6.2.1;
• Reset two spacers and two motors with spirals (see fig 38
position 3,4) one step in the installation spot on the shelves.
When selling wide dimensional products, it is recommended to
use higher vertical spacers (see fig 43).
93 mm
132 mm
Page 75