Changing The Configuration Of Shelves - Unicum FOODBOX LIFT TOUCH User Manual

ТМ
FOODBOX TOUCH, FOODBOX LONG TOUCH, FOODBOX LIFT TOUCH

12.0 CHANGING THE CoNfIGURATIoN of SHELVES

All operations described in this section are carried out with the vending machine disconnected from
the mains!
Pull out the shelf and free it from any products.
Set the optimal position of spiral ends. For this pull out the spiral in accordance with fig. 33, turn in
through 45° or larger angle multiple of 45° and release.
Changing spirals
Disconnect the electric motor power connectors (fig. 34, pos. 1) and pull out the shelf.
ATTENTIoN!
To avoid vending machine overturning don't pull out all shelves simultaneously!
If the factory installed spiral is not adequate for selling products, you can select a spiral, corresponding
with the product dimensions, and replace the factory installed spiral.
Turn the spiral with left spooling counter-clockwise (in the case of right spooling - clockwise) until the
spiral end clicking position and remove the spiral from the holder (fig. 35).
Version 1.3 / December 2018
45
0
figure 33
1
figure 34
figure 35
Page 54