Changing Shelf Configuration; Changing The Spirals - Unicum FOODBOX User Manual

ТМ
Setting the dispensing tray to the machine:
- install back the dispensing tray in the Machine, by placing it in-between the guides, which are in-
stalled on the side walls of the body. Be careful to make sure that the earthing cable would not be damaged
or pressed during this process;
- Connect the tray's earthing to the Machine's body (see figure 33 position 4);
- Reinstall the cover (see figure 25 position 3) and fix it using the bolts (see figure 33 position 2);
- Reinstall the dispensing tray, tightening the upper and lower fixtures (see figure 32);
- Install and fit the ventilation cover, tightening the fixtures (see figure 31).
ATTENTION! It is prohibited to allow damage to the pipes, condenser screens, evap-
orator and other parts of the refrigeration unit, which violate the unit's integrity and
airtightness. If you discover any such damage it is prohibited to turn the Machine ON!
In this case open all the windows and ventilators in the premises. To repair the damage
please contact the service center. It is prohibited to let the earthing cables be damaged.

4.6 CHANGING SHELf CoNfIGURAtIoN

45
Fig.34

4.6.1 Changing the spirals

Disconnect the electric motors' connectors (see fig 35 position 1) and pull out the shelf (see fig.35)
Version 3.4 / November 2016
FOODBOX / FOODBOX LONG
Pull-out the shelf and vacate it.
To give optimum positioning to the spiral ends, according to figure
36 pull the spiral and turn it by 45
and release it.
0
1
Fig.35- Dispensing compartment shelf
or greater angle (45
0 0
multiple)
Page 72