Description; Specifications; Educational Services - Emerson Fisher KC Series Instruction Manual

4195KA, KB, KC, and KS Controllers
Portions of this manual apply only to specific 4195K
Series controller configurations. These
configurations are indicated by letter suffixes in the
type number that correspond to the mode and option
designated in table 1-2.
The specific controller type number (with letter
suffixes) is located on the nameplate shown in figure
1-1. Refer to table 1-2 for the definition of each
4195K Series type number.
Do not install, operate, or maintain this product
without first D being fully trained and qualified in
valve, actuator, and accessory installation,
operation, and maintenance, and D carefully reading
and understanding the contents of this manual. If
you have any questions about these instructions,
contact your Emerson Process Managementt sales
office before proceeding.

Description

The controllers described in this manual provide
gauge pressure control with the options as shown in
table 1-2.
D 4195KA Series: Proportional-only control
D 4195KB Series: Proportional-plus-reset control
D 4195KC Series:
Proportional-plus-reset-plus-rate control
D 4195KS Series: Differential gap control
These controllers show process pressure and set
point on an easy-to-read process scale. The
controller output is a pneumatic signal that operates
a final control element.
1-4

Specifications

Specifications for the 4195KA, KB, KC, and KS
Series controllers are listed in table 1-1.

Educational Services

For information on available courses for the 4195KA,
4195KB, 4195KC, and 4195KS Series gauge
pressure indicating controllers, as well as a variety
of other products, contact:
Emerson Process Management
Educational Services, Registration
P.O. Box 190; 301 S. 1st Ave.
Marshalltown, IA 50158−2823
Phone: 800−338−8158 or
Phone: 641−754−3771
FAX: 641−754−3431
e-mail: education@emersonprocess.com
Neither Emerson, Emerson Process
Management, nor any of their affiliated
entities assumes responsibility for the
selection, use, and maintenance of
any product. Responsibility for the
selection, use, and maintenance of
any product remains with the
purchaser and end-user.
Instruction Manual
Form 5207
April 2007
Note