Fujitsu MB91460 SERIES User Manual page 37

SK-91467R-176PMC User Guide
Chapter 5 Programming the internal Flash
RESET MCU
Figure 5-1: Settings for Automatic Mode
7) If your hardware supports MCU reset via DTR or RTS signal lines of the PC's COM
port, go to sheet "Signals" and select the appropriate reset signal line. The
programmer now resets the microcontroller automatically before starting the
programming sequence and you do not have to reset the MCU manually immediately
after pressing the button "Automatic Mode".
Figure 5-2: Reset Signal Settings
© Fujitsu Microelectronics Europe GmbH - 37 - FMEMCU-UG-910053-16