Fujitsu MB91460 SERIES User Manual page 18

JP5
(VCC5_2)
JP6
(VCC5_3)
JP7
(VCC3)
JP19
(Power)
JP69, 79, 89, 99
(VBAT)
By default, all Board supplies are set to 5V.
FMEMCU-UG-910053-16
SK-91467R-176PMC User Guide
Chapter 3 Jumpers and Switches
Closed Power supply VCC_2 connected to MCUVCC5_2
Open Power
MCUVCC5_2
Closed Power supply VCC_3 connected to MCUVCC5_3
Open Power
MCUVCC5_3
Closed Power supply VCC3V3 connected to MCUVCC3
Open Power
MCUVCC3
Closed Board is always on
Open S3 switches the Board on and off
Closed Vs (Pin1) of LIN connector is powered by the board
Open No voltage supply to Vs of LIN
Table 3-5: Power Supply Configuration
+5V
+3.3V
+2.5V
+1.8V
Figure 3-3: Voltage Test Pins
supply VCC_2
supply VCC_3
supply VCC3V3
GND
- 18 - © Fujitsu Microelectronics Europe GmbH
not connected to
not connected to
not connected to