Table of Contents
Advertisement
ANNEX 3
After scanning the whole TV band, I cannot find the
Problem:
digital service.
Possible
-
solution:
-
-
-
After scanning the whole TV band, it finds the service but
Problem:
it is not saved on the desired position.
Possible
-
solution:
-
TV shows on screen a message similar to this one:
Problem:
"Network parameters have changed. Do you want to
scan again?"
Possible
-
solution:
TV audio saturates.
Problem:
Possible
-
solution:
03-2012
TROUBLESHOOTING
Check the frequency you are using is not already in
use in a channel of the distribution network.
Check that NID and ONID parameters correspond
to your country. Check the recommended table
values.
Check the TS-ID is not the same as the one already
being used in the TV distribution network or as the
one used in any other EN-106 module.
Check attenuation and put it to 0 dB.
Check the LCN is correct.
Review
NID,
values. Check the recommended table values.
Check
the
NIT
recommended in the table for all modules.
Reduce the audio gain.
USER'S MANUAL. EN-106
ONID
and
Private_Data_Specifier
version
and
use
the
one
Page 24
Advertisement
Table of Contents
