Table of Contents
Advertisement
REMKO EMF / EMT
n
The failure of important unit functions.
The failure of prescribed methods of mainte-
n
nance and repair.
n
Danger to people on account of electrical and
mechanical effects.
1.5
Safety-conscious working
The safety notes contained in this installation and
operating manual, the existing national regulations
concerning accident prevention as well as any
internal company working, operating and safety
regulations must be observed.
1.6
Safety notes for the operator
The operational safety of the units and compo-
nents is only assured providing they are used as
intended and in a fully assembled state.
n
The units and components may only be set up,
installed and maintained by qualified per-
sonnel.
Protective covers (grille) over moving parts
n
must not be removed from units that are in
operation.
n
Do not operate units or components with
obvious defects or signs of damage.
n
Contact with certain unit parts or components
may lead to burns or injury.
The power supply should be adapted to the
n
requirements of the units.
n
Tripped circuit breakers may only be replaced
by those of identical construction.
n
In the event of defects that endanger the
operational safety of the units, operation must
be discontinued.
The units and components must not be
n
exposed to any mechanical load, extreme
levels of humidity or direct exposure to sun-
light.
n
Regulations such as the regional building regu-
lations and the Water Ecology Act must be
observed.
n
In the event that refrigerant has leaked from
the indoor unit, the room must be properly ven-
tilated before the unit is re-started. Otherwise
there is danger of suffocation.
n
All housing parts and device openings, e.g. air
inlets and outlets, must be free from foreign
objects, fluids or gases.
n
The units must be inspected by a service tech-
nician at least once annually. Visual inspec-
tions and cleaning may be performed by the
operator when the units are disconnected from
the mains.
6
1.7
Safety notes for installation,
maintenance and inspection
The operator must ensure that all installation,
maintenance and inspection work is carried out by
authorised and qualified personnel who have thor-
oughly read the installation and operating manual.
The procedure for shutting down the units as
described in the installation and operating manual
must be followed in its entirety.
All safety and protection devices must be re-
attached and restored to working order immedi-
ately upon completion of the work.
Appropriate hazard prevention measures must
n
be taken to prevent risks to people when per-
forming installation, repair, maintenance or
cleaning work on the units.
n
The setup, connection and operation of the
units and its components must be undertaken
in accordance with the usage and operating
conditions stipulated in this manual and comply
with all applicable regional regulations.
n
Units may only be mounted at the points pro-
vided for this purpose at the factory. The units
may only be secured or mounted on stable
structures, walls or floors.
n
Mobile units must be set up securely on suit-
able surfaces and in an upright position. Sta-
tionary units must be permanently installed for
operation.
n
The units and components should not be oper-
ated in areas where there is a heightened risk
of damage. Observe the minimum clearances.
The units and components must be kept at an
n
adequate distance from flammable, explosive,
combustible, abrasive and dirty areas or
atmospheres.
1.8
Unauthorised modification
and replacement part manu-
facture
Modifications or changes to units and components
are not permitted and may cause malfunctions.
Safety devices may not be modified or bypassed.
Original replacement parts and accessories
authorised by the manufactured ensure safety. The
use of other parts may invalidate liability for
resulting consequences.
1.9
Intended use
Depending on the model, the equipment and the
additional fittings with which it is equipped is only
intended to be used as an air-conditioner for the
purpose of cooling or heating the air in an
enclosed room.
Advertisement
Table of Contents
