Table of Contents
Advertisement
REMKO EMF / EMT
1
3
>= 1500
>= 600
Fig. 30: Minimum distances for installation of several outdoor modules in mm for EMF/EMT 100
1
Against a wall, facing the wall air outlet, flow
front restriction
2
In a niche, free flow air to the front, rear and flow
restriction on both sides.
Condensate draining and ensured discharge
Condensate connection
If the temperature falls below the dew point, condensation will form on the finned condenser during heating
operation.
A condensate drip pan should be installed on the underside of the unit to drain any condensate.
n
The condensate drain pipe to be installed on-site must be installed with a in cline of at least 2 % for good
drainage. If necessary, fit vapour density insulation.
n
When operating the system at outdoor temperatures below 4 °C, care must be taken that the condensate
line is frost protected. The lower part of the housing and condensate pan are to be kept frost free in order
to ensure permanent drainage of the condensate. If necessary, fit supplementary pipe heating.
n
After completed installation, check that the condensate drainage is unobstructed and ensure that the line
is leak tight.
Ensured discharge in the event of leakage
NOTICE!
Local regulations or environmental laws, for example the German Water Resource Law (WHG), can
require suitable precautions to protect against uncontrolled draining in case of leakage to provide for safe
disposal of escaping refrigerator oil or hazardous media.
30
>= 3000
>= 3000
2
>= 300
4
>= 600
>= 300
3
Between two walls, facing the wall outlet and
other modules, Sides: flow restrictions in front
and rear
4
Between two walls, air outlet towards wall, or the
external modules-free: flow restriction in front,
rear and internal modules on the sides.
>= 600
>= 600
>= 600
>= 600
Advertisement
Table of Contents
