Commissioning; Control Panel - REMKO EMT 100 Assembly And Operating Instructions Manual

REMKO EMF / EMT
Fig. 53: Auxiliary relays
9

Commissioning

9.1

Control panel

Fig. 54: Control panel
1. Mode switch
2. Green indicator light: outdoor module is acti-
vated
3. Orange indicator light: operation 2nd heat
source
Position I: Normal operation
This switch turns on the system. The heat pump and a possible 2nd heat source (6 kW E-heater or boiler),
load- and weather-dependent, are turned on and off - as well as regulated - automatically.
Position 0: OFF
Position II: Emergency-heat operation
54
1
2
3
4
6 5
4.
5.
6.
Red indicator light: outdoor module failure
White indicator light: drinking water preparation
is activated
Heat pump manager (Control and display unit)
This switch directly turns on all circulation pumps
and the 2nd heat source (9 kW E-heater or boiler),
bypassing the heat-pump manager. Use this posi-
tion only if a serious malfunction of the heat pump
occurs (e.g.: a fault in the outdoor module or
in the heat-pump manager). This function might
also be helpful if heat is ever required and the out-
door module has not yet been installed or or
placed in service.