Heat Pump Manager Multi-Talent Plus (Heat Flow Meters) - REMKO EMT 100 Assembly And Operating Instructions Manual

REMKO EMF / EMT
n Check which system schematic is used (see
the hydraulic schematic in the heat-pump man-
ager handbook).
n If the System 1 schematic is applicable, you
need only press the F-button next to End.
Should a different system schematic be
selected, press the F-button next to OK to
begin installation.
The configuration in the installation level for the
n
selected hydraulics has to be completely pro-
grammed with the parameters that go with
it (see the hydraulic schematic in the heat-
pump manager handbook).
The system has to be matched to the custom-
n
er's personal values (e.g. inlet temperature).
n The brief instructions supplied give an over-
view of how to set the most important values.
n After configuration, the system is to be run-in
and the measured values are to be recorded in
the commissioning report.
NOTICE!
The commissioning and programming of the
heat-pump manager may be carried out only
by an installer authorized by REMKO.
Please review the heat-pump manager manual
for important details about successful commis-
sioning.
During commissioning, only a typical heat-
manager pre-set is made. Individual settings
must be optimized for construction materials
and the practices of various users. Especially
during the first heating period.
9.3 Heat pump manager Multi-
Talent Plus (heat flow
meters)
The Multitalent heat pump manager PLUS is
equipped with the following displays relevant for
the heat flow meters:
Display level
The displays relevant to the heat flow meters are
called up with the following steps on the heat pump
manager.
56
Level 0
Fr 23 Apr 10 16:05
T-external
T-collector
Heating
Level 1
Main menu
01
Terminal
Controller
Level 2
Controller
01
Display
User
Time programme
Level 3
Display
01
Plant
Hot water
Heating circuit 1
Level 4
Plant
07
Flow volume 28 l/min
Current output 8070 W
Output day 30.2 kWh
Level 4 (continued)
Plant
07
Output day 30.2 kWh
Output total 99 kWh
Error
Fig. 58: Display level
Specialist level
The heat pump menu is found in the specialist
level. The parameters for the heat flow meters are
configured here.
19.0 °C
36.2 °C
Home
End
End
End
End
End
00