Tig Welding; Tig Comfort Stop - Fronius TransPocket 150 Operating Instructions Manual

TIG welding

1
2
3
4
5
6
7
8
4

TIG Comfort Stop

NOTE!
To enable and set the TIG Comfort Stop function, see the description of the "Comfort
Stop Sensitivity" (Comfort Stop Sensitivity) parameter in the "Welding process Set-
up menu" section.
Operating principle and use of the TIG Comfort Stop:
1
1
2
3
Select TIG welding with the welding process button
the TIG welding indicator lights up
Press the setting value button until
the welding current indicator lights up
Adjust the welding current using the adjusting dial
Place the gas nozzle down on the ignition location, ensuring there is a gap of approx.
2 to 3 mm (5/64 to 1/8 in.) between the tungsten electrode and the workpiece
Actuate the gas cut-off valve
- Shielding gas flows
Gradually tilt the welding torch up until the tungsten electrode touches the workpiece
Raise the welding torch and rotate it into its normal position
- The arc ignites
Carry out welding
2
Welding
During welding, raise the welding torch
- The arc length is increased significantly
Lower the welding torch
- The arc length is decreased significantly
- The TIG Comfort Stop function is activated
6
3
7
4 + 5
35