COLLABORATE LIVE 900 COMPONENTS INCLUDED COLLABORATE Live 900 COLLABORATE Live codec with power supply, COLLABORATE Remote control with dongle, and HDMI cable. 910-2100-003 UNITE 200 PTZ camera, power supply, HDMI cable and RS232 Serial Control cable. Note: The remote control...
QUICK-START GUIDE MAKING THE CONNECTIONS Connect the Beamforming Microphone Array 2 to the CONVERGE Pro 2 48V. Then, connect the CONVERGE Pro 2 48V, UNITE 200 camera, Ethernet, and monitor(s) to the COLLABORATE Live codec as shown. UNITE Camera 1080p HDMI Camera Video Display Port HDMI Camera Serial Control...
Page 4
COLLABORATE LIVE 900 CONNECTING THE REMOTE CONTROL DONGLE The Remote Control includes a dongle that plugs into the FRONT USB port on the codec.
QUICK-START GUIDE CONFIGURING DISPLAY SETTINGS After all peripherals are connected to the unit, turn the unit on. Once COLLABORATE Live is loaded – you will see your local camera video on your screen. Using the remote control, navigate to the display settings: Settings >...
COLLABORATE LIVE 900 CONFIGURING AUDIO SETTINGS The COLLABORATE Live audio input and output is Converge Pro. Verify this in COLLABORATE Settings > Audio & Video...
QUICK-START GUIDE CONFIGURING NETWORK SETTINGS Using your remote control, navigate into the network settings: Settings > Advanced > Network The COLLABORATE Live obtains its IP automatically by default from the DHCP server. Set “Obtain Address From DHCP” to “Disabled” to manually configure network settings.
Need help?
Do you have a question about the COLLABORATE Live 900 and is the answer not in the manual?
Questions and answers