Honeywell X Series User Manual page 91

An event is made up from a Cause and an Effect. For example set up a cause, such as Pen
1 going into an alarm state and the effect of this could be to start a totaliser or acknowledge
the alarm.
Select the first available event eg. Event 1. In the Event 1 menu tick to enable and change
the Event tag if required. Each Event has four Causes and four Effects available, these can
be used in different combinations:
In summary Cause 1, 2, 3 or Cause 4 will trigger Effect 1, 2, 3 and Effect 4.
When selecting Totalisers and Alarms etc. ensure they are enabled and configured in the
Pens menu.
43-TV-25-30 Iss.6 GLO Aug 07 UK
NOTICE
Remember that any of the Causes will trigger All the Effects.
Cause 1 and Effect 1 are not linked.
• An event can have up to 4 causes that triggers just one effect eg. A pen going into
alarm, a Totaliser starts, Max/Mins reset and a Batch starts. This could have the effect
of starting Logging.
• An event can have one cause that has up to 4 effects, eg. A pen could go into alarm and
the effects could be that the alarm is acknowledged and a Totaliser is started, there is a
Mark placed on the chart and an Alarm is sounded. See
page 87
.
• An event can have up to 4 causes that have up to 4 effects, eg. A pen goes into alarm
and a Totalisers is started, A scheduled export starts and Max/Min values are reset. The
effects could be the alarm is acknowledged and a mark on chart is displayed to show
the start of the totaliser, an Email is sent to notify a scheduled export has been made
and a sound effect is played to identify the Max/Min values have been reset.
"Event 1 example:" on
85