Pulse Input Channel Numbers; Pulse Input Connection Details - Honeywell X Series User Manual

Pulse Input Channel Numbers

The Pulse Input card has channels using a connector that only takes up half the length of
the connector slot. Looking from the rear of the unit the Pulse Input connector is on the right
of the slot with a blanking plate on the left.

Pulse Input Connection Details

Do not connect anything to terminals marked NC (Not Connected). For Frequency and Volt-
age levels see
43-TV-25-30 Iss.6 GLO Aug 07 UK
WARNING
HAZARDOUS VOLTAGES
Insulation from channel to channel: Normally a channel can be safely connected to a
hazardous voltage up to 300V AC common mode* with respect to earth. However,
where a channel is connected to a safety low voltage circuit, an immediately adjacent
channel must be adequately insulated from hazardous voltages between 150V AC
and 300V AC max. This insulation should comprise of at least 1.5mm air gap, or a bar-
rier rated greater than 1400V AC. This is to ensure that protection of the safety low
voltage circuit is fully maintained.
*Common Mode" voltage is a voltage applied between the whole channel and earth,
not between pins on a channel. 300V AC is permitted at Measurement Category CAT
ll (Overvoltage Category ll)
Failure to comply with these instructions could result in death or serious injury.
Slot A
Card Position
Channel number 1 to 4
"Specification Tables" on page
Channel 1
-
Table 2.5 :
Pulse Input card
Slot B Slot C
9 to 12 17 to 20
259.
Channel 2
+ NC - + NC -
Slot D Slot E
25 to 28 33 to 36
Channel 3 Channel 4
+ NC - + NC
Slot F
41 to 44
23