Programming the Remote Control
When the unit is in Standby mode (the display shows "– –") press and
1.
release the learn button in order to learn the remote control. The LED display
will show Ln.
2.
Press one key on the remote control twice within 2 seconds. The display will
flash Ln for 4 seconds. Afterwards the display will turn to "– –". The remote
control has been learnt successfully.
If you want to use more remote controls, repeat the above mentioned steps.
Up to 6 remote controls can be programmed. If you lose one remote control,
for safety reason, please program all other remote controls to have a new
code.
Erase all Remote Control Codes
Press and hold the learn button until the LED display shows "dL". Now all
1.
remote codes have been erased. Release the learn button and the display
turns back to "– –".
2.
For programming the remote control again, see chapter above.
Please instruct all persons how to use the gate opener correctly and safely.
The swing gate opener can be operated with the included remote control as
soon as the remote control is learned.
Programming
26