Mounting And Connecting The Control Box - Westfalia 18 39 13 Instruction Manual

Mounting and connecting the Control Box

1. Mount the control box (2) with suitable
screws and dowels for the resp. surface.
Preferably mount the control box approx.
150 cm above the ground. Make sure
the control box is not exposed to direct
sunlight, rain, snow or direct water jet
(high pressure water jet etc.).
2. Unscrew the lock nuts of the strain
relief and insert the power cable of the
gate opener from below into the control
box. Pull enough cable and tighten the
lock nuts of the strain relief.
The cables are labelled with small flags.
Please observe the flags and arrange
them correctly.
Order of the cables for Gate Opener 1:
Red cable to +Motor1
Black cable to –Motor1
Red cable to ULT1
Black cable to COM
Yellow cable to DLT1.
Order of the cables for Gate Opener 2:
Red cable to +Motor2
Black cable to –Motor2
Red cable to ULT2
Black cable to COM
Yellow cable to DLT2.
Please also observe the wiring diagram on
the next page.
Screws and
dowels
(not
included)
16
Opener 2
Opener 1