Hints - Westfalia 18 39 13 Instruction Manual


Power cable (red doted line shown in the picture on page 5) must be put into
a PVC conduit and placed underground in order to avoid damaging the
cables. If digging is not possible, put the power cable into a PVC conduit that
is stable enough to withstand vehicles passing over.

The swing gate opener is operated with 230 V~ 50 Hz. The electrical wiring
should be exclusively for the gate opener and it should be additionally
protected by a 10 A fuse.

Power supply should be connected with an EMERGENCY-STOP-Main
Switch. In case of questions, contact a professional.

For correctly programming the gate openers, it is essential that gate opener 1
is mounted at the right side of the gate and gate opener 2 is mounted at the
left side of the opener (view from
inside of the property).

The gate opener must be mounted
that way, so the motor is facing
downwards.

One or both gate openers can be
either mounted at the middle of the
gate (this will be the best static
position) or at the bottom of the gate
(for a uniform appearance).

If the gate system does not have
vertical braces or a horizontal cross
member, then the gate system has
to be reinforced prior to mounting
the gate opener.

Hints

6
Cross Member
Vertical Brace