Westfalia 18 39 13 Instruction Manual page 18

1. Mark the drilling holes through the
bracket assy and drill holes with 10 mm
diameter into the gate post.
2. Mark the drilling holes through the gate
bracket and drill holes with 10 mm
diameter into the gate.
3. Tighten all screws and nuts. Protruding
bolt ends (10) should be cut with the
hacksaw.
Cover the gate opener while drilling. Please note that dust and swarf might
damage the gate opener.
Use the included screws or other suitable screws and dowels for the resp.
surface.
Mounting
Gate is in OPEN Position
14
Drill Holes
Bracket Assy
10 mm Holes