Advertisement
Introduction
This guide covers the installation and setup of the basic IVPC Wireless Intercom System. The basic system
contains an IVPC-DS door station and an IVPC-MS mobile station or a device running the OPTEX Vision App.
By the end of the steps, you will be ready to try some of the operations covered in the user manual.
Thank you for choosing OPTEX!
General Information
Power on
(Wired operation)
Power on
(Battery operation)
Wi-Fi pairing mode
Active Call/Live View
Active Call/Live View
(2-way Audio Activated)
* Low battery warning: The device will cease to function within a week if not recharged
** Low battery error: The battery is completely drained. Please recharge immediately.
*** Device error: Please contact a service provider.
IVPC-DS
Front view
HD camera
Light sensor
Microphone
LED indicator
Doorbell
button
Speaker
<<
>>
LED indications
Rear view
(Mounting plate/
back cover removed)
INT/EXT
Mounting plate
Back cover
SETTINGS and INSTALLATION GUIDE
Door station
Mobile station
or a device (not included) running the OPTEX Vision App.
*Low battery Warning
Solid light (White)
** Low battery error
LED OFF
Battery power charging
White & Blue alternating
Firmware update in progress
Slow blinking (White)
*** Device error
Solid light (White)
AC/DC power Input
External antenna jack
Internal/external
antenna switch
Internal 5,000 mAh
rechargeable battery
Device ID
Back up QR code
Factory reset
(Do not remove)
(Press & hold for 5 seconds, until
white & blue LED starts blinking)
< Accessories >
Screw pack
- 1 -
IVPC-DS
IVPC-MS
Slow blinking (White)
Bottom view
1.Open the rubber bushing
Micro USB port
(For battery charging)
* Lift rubber plug for access.
USB charging cable
Cable connector
No.59-2723-5 1904-09
EN
Slow blinking (Blue)
Fast blinking (Blue)
Full charged
off
Solid light (Blue)
Fast blinking (Blue & White)
2. Open the front cover
Power on/off
(Short press to turn
power on/off)
*Memory card slot
(Memory card is installed
as a factory default)
Bypass cable
Power cable
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Optex IVPC-DS
Summary of Contents for Optex IVPC-DS
- Page 1 This guide covers the installation and setup of the basic IVPC Wireless Intercom System. The basic system contains an IVPC-DS door station and an IVPC-MS mobile station or a device running the OPTEX Vision App. By the end of the steps, you will be ready to try some of the operations covered in the user manual.
-
Page 2: What To Expect
Password; Password; - Peel the Device ID (DID) QR code from the mounting plate of the IVPC-DS and place on the space provided below. - Note the location name, changed Device password and Admin password set during the installation. - Hand the user this page when the installation process is finished for their record. - Page 3 Do not use other AC/DC Caution adapter than included. << >> To use the system with a device running the OPTEX Vision App. (option) Download OPTEX Vision Visit either “App store” Search “OPTEX Vision” Find “OPTEX Vision” or “Google play” .
- Page 4 >> To use the system with a device running the OPTEX Vision App. (option) - Follow the guidance on the screen to register the IVPC-DS to a device running the OPTEX Vision App. NOTE - Reference Step 1 or scan the QR code on the Start up Start and end of the registration steps back side of the IVPC-DS to get the Device ID.
- Page 5 *1 The back cover protects against water intrusion. Make sure nothing is interfering with it. *2 If the power source is kept off, the IVPC-DS is driven by the inner battery. It may cause unexpected system shutdown if power is not restored before the battery depletes.
-
Page 6: Confirm Operation
After completing installation, follow up with a final operation test: 1. Push the doorbell button on the IVPC-DS to confirm audio and video on the IVPC-MS or a device running the OPTEX Vision App. 2. Go through the settings section of the user manual to customize the settings. -
Page 7: Specifications
This equipment complies with IC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter (see **). ** For the IVPC-DS, the equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. - 7 -... - Page 8 Check point Solution Did something go wrong during the wizard? Press and hold the factory reset button on the IVPC-DS, to enter the e.g. Wi-Fi password is incorrect. Wi-Fi registration mode. Retry to set each item. The registration was not completed Communication status with the Wi-Fi router is not successfully.
Need help?
Do you have a question about the IVPC-DS and is the answer not in the manual?
Questions and answers