Display Assembly - HP Stream PC 14-ax1 Series Maintenance And Service Manual

Display assembly

NOTE: The display assembly is spared at the subcomponent level only. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Remove the WLAN antennas from the routing path in the computer (1).
2. Remove the four Phillips PM2.5×5.0 screws (2) that secure the display assembly to the computer.
3. Lift the display assembly from the computer (3).
4. If it is necessary to replace the display bezel:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display back cover.
b. Remove the display bezel (4).
The display bezel is available using the following spare part numbers:
905559-001 for blue models
910177-001 for white models
928418-001 for black models
Bottom cover on page 24).
Battery on page 25).
Component replacement procedures 37