Wired Ethernet Network Setup - Cardiac Science Burdick 8300 Network Setup Manual

Network Connection Set-up

Wired Ethernet network setup

Note: This procedure assumes you have a functional Ethernet network. If not, setup and test
your network before attempting to connect your 8300/8500. It is easier to test out Ethernet
network configurations using a PC or laptop first, and then attempt to add your 8300/8500
to the network. The 8300/8500 needs almost the same configuration information as a PC.
To configure the ECG device for use with a wired Ethernet network:
Press Setup,
1.
Use the arrow keys (Next and Previous) to scroll to Network connection and press
2.
Select.
Refer to the Network connection worksheet on page 1-2 to configure the network
connection fields. The fields that appear depend upon the network type that was
selected.
Enter your UTC/GMT time zone offset.
3.
This is the offset in hours (and optional minutes) the device applies to correct for your
timezone.
Note: You may need to subtract an hour from your offset during Daylight Savings Time
(or your local equivalent) if your region requires it.
Example: For Central Time zone (USA) enter "6" (winter) or "5" (summer), for Pacific
Timezone (USA) enter "8" (winter) or "7" (summer), for Amsterdam enter "-1", and for
Newfoundland enter "3:30".
Connect the ECG device to your network.
4.
Attach an RJ-45 cable to the RJ-45 port on the back of the ECG device and attach the
other end to an available RJ-45 Ethernet network port.
To complete the configuration see one of these sections:
5.
Chapter 2, Exporting to Network Share
•
Chapter 3, Web Services Communications
•
Chapter 4, Network Printing
•
70-00900-02 C
1-6
Burdick 8300/8500