Control Interrupttriggering - Siemens SIMATIC S5 Equipment Manual

R 02/92
9.5.11 Control Interrupt Triggering
If the interrupts assigned to the applicable tracks were enabled during startup, they can be tempo-
rarily inhibited during the cycle. All interrupts can be inhibited by setting input 14.5. Another activa-
tion of input 14.5 cancels the interrupt inhibit. The status byte then has the following bit pattern.
Direct parameterization (PB 11)
KM = 0110XXM
KM = OOOOxxxx
Indirect parameterization (FB 11 )
KM = 01 IOxxxx
KM = OOOOxxxx
Input 14.6 can only be used to affect the interrupt generated by the module while modifying track
setpoints. This interrupt is also inhibited by a one–time activation of input I 4.6; the interrupt is
enabled by repeating the procedure. The status information is as follows:
Direct parameterization (PB 11)
KM = OO1O)O(XX
KM = OOOOXXXX
Indirect parameterization (FB 11)
KM = OO1O
KM = OOOOXXXX
No.: 6E~ gg8-I)KD21
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(Control information: interrupts inhibited
x = "O" or"1" depending on the processing
point)
(Control information: interrupts m inhibited
x = "O" or"1" depending on the processing
point)
(Working data block)
(Control information: interrupts inhibited
x = "O" or"1" depending on the processing
point)
(Control information: interrupts ~ inhibited
x = "O" or "l" depending on the processing
point)
(Control information: interrupt inhibited for
supply, x = "O" or"1" depending on the
processing point)
(Control information: interrupt @ inhibited for
supply, x = "O" or"1" depending on the
processing point)
(Working data block)
(Control information: interrupt inhibited for
XXXX
supply, x = "O" or"1" depending on the
processing point)
(Control information: interrupt m inhibited for
supply, x = "O" or"1" depending on the
processing point)
Programming Instructions
9 – 55