Setting The Encoder Powersupply - Siemens SIMATIC S5 Equipment Manual

Matching Module 4 for Absolute Encoders
Maximum resolution = 20 bits + 1 control bit
Without being converted on the encoder matching module, the actual values are directly trans-
ferred to the basic module via the output memory (when setpoints are presented in BCD code, the
processing time of the basic module must be taken into account). Solder in jumper BR1 for
"BCD/BIN".
7.3.2 Setting the Encoder Power Supply
The required encoder supply voltage must be provided by circuitry of resistor R31 on the absolute
encoder matching module.
Required voltage
+5 V/1 A
+ 15 V/l A
of the SS1 submodule in section 7.3.8.
7 – 8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1.3 I& MBB 0207
4.3 k~ MBB 0207
5.6 k~ MBB 0207
No change required as the 24 V supply is fur–
tor on the basic module.
R 02/92
Pin No.
32/48
32/48
32/48
49