Parameterassignment - Siemens SIMATIC S5 Equipment Manual

9.3.4 Parameter Assignment
x = Track number
SPDB : ~ =
X, y
The track number is dependent on the parameter BEF:
Y
: KS = KB Only output of identifier bits and control bits
KS = AE Modifying the setpoints of a track
KS = SS Software-based synchronizing
Hardware– based synchronizing
KS = SH
KS = IW Output of the actual value
KS = AW
Output of the initial setpoint
KS = EW Output of the end setpoint
KS = IS Inhibit interrupt
KS = IV Inhibit interrupt for supplying the module with new setpoints
KS = N1 Zero shift, read channel 1
KS = N2 Zero shift, read channel 2
KS = PR Verify read
KS = MB Calculate average value
KS = RV Inhibit interrupt depending on direction
The identifier bits and the control bits are updated at each command.
x = Enable reset
: KY = x, y
Y
Parameter ABIT only with S5–150U/S and S5–155U
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
= x <31
track number
x =
32 Zero shift Channel
Zero shift Channel
x = any choice
=
1< y <255
2< y <255 with S5–155U and S5–135U
x ><0 No reset
x = O Reset of the corresponding interrupt bit in the system
data
=
bit number
Programming Instructions
I
2
9 – 17