Siemens SIMATIC S5 Equipment Manual page 18

Note 1 (for positive values):
I
i
I
I
Traversing direction
I
"o"
" ,, 1
"o"
99
100
Aside from the traversing direction the following applies:
When the first cam value in traversing direction is reached, the track identifier bit is set (or reset
respectively).
When the cam end is reached in the same direction, the track identifier bit by then is already reset
(or set respectively).
tions, the end value (or the initial value respectively) must be increased by one.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
I
Total track area
I
i
I
I
raversing direction
199
General Function Description
— I
Track identifier bit (A= 100, E = 200)
Track identifier bit (E = 100, A = 200)
1 – 9