Malvern Mastersizer Series Getting Started page 70

C H A P T E R 4
'
N O T E
If you are not in the
Measure-Inspect
dialogue then you can
select the
Measure-Sample
dialogue by selecting
Sample from the
Measure menu.
P a g e 4 . 1 4
G e t t i n g S t a r t e d
. Press the Start button and the measurement will start. The Start button
will change to "Stop" allowing you to stop the measurement if you require.
Once the measurement is complete the button will change back to say
"Start".
The measurement is now complete. The next procedure to follow is the analysis
of the data you have just measured. This is described in the next chapter. At this
point you have the option of saving your measurement data - for this
demonstration though we will carry on with the analysis and save the result later.
The dialogue at present will still show the Measure-Sample dialogue. It is
possible to press the Next button that will take you to the next logical step in the
procedure - analysis of the data. At this point it is not recommended as it will
analyse the data using the parameters of the last sample analysed. It will be of
more benefit to you to follow the procedure in the next chapter that will explain
the setup of the analysis.
To close down the Measure-Sample dialogue press the Close button.
M A N 0 1 0 1