Malvern Mastersizer Series Getting Started page 18

C H A P T E R 1
P a g e 1 . 6
G e t t i n g S t a r
Chapter 4 - Making a measurement.
Chapter 4 will guide you through the practical steps needed to make a
measurement to obtain the raw data.
Chapter 5 - Analysing the measurement data.
This chapter will show you how to take the raw measurement data and analyse it,
using the Malvern software, to get a final result. Advice is given on the choice of
optical model and the presentation.
Chapter 6 - Viewing the results.
The Mastersizer software has several standard viewing formats that allow you to
display and print the results in different ways. This chapter explains the standard
views and how to print them.
Chapter 7 - Interpreting the results.
This chapter gives some essential advice on understanding the results given by the
software.
Chapter 8 - Automating the procedure.
This chapter gives a brief overview of the procedures involved in measuring and
analysing a sample by setting up a semi-automatic sequence.
Chapter 9 - Sample preparation.
Sample preparation is one of the most important stages in making a measurement
on the Mastersizer. This chapter gives additional advice to that covered in the
chapter 4.
Chapter 10 - Advanced result processing.
The Mastersizer software gives the option to perform some advanced result
manipulation. This chapter gives an overview on some of the options.
Chapter 11 - Routine maintenance.
The Mastersizer has no user serviceable parts but there are certain maintenance
routines that can be carried out by the user. These include cleaning the optics etc.
This chapter gives advice on these routines.
Appendices.
At the rear of the manual is a series of appendices that cover some of the technical
aspects of the Mastersizer, including the technical specification.
t e d
M A N 0 1 0 1