Security Instructions - HOLZMANN MASCHINEN HBS 300J User Manual

15.2 Security instructions

Missing or non-readable security stickers have to be replaced immediately!
To avoid malfunction, machine defects and injuries, read the following security instructions!
The locally applicable laws and regulations may specify the minimum age of the operator and limit
the use of this machine!
 Keep your work area dry and tidy! An untidy work area may cause accidents. Avoid
slippery floor.
 Make sure the work area is lighted sufficiently
 Do not use the machine outdoors!
 Avoid abnormal working postures! Make sure you stand squarely and keep balance
at all times.
 Keep away from the running saw band!
 Always stay focused when working. Reduce distortion sources in your work-ing
environment. The operation of the machine when being tired, as well as under the
influence of alcohol, drugs or concentration influencing medicaments is forbidden.
 The machine shall be operated by respectively trained persons only.
 Do not allow other persons, particularly children, to touch the machine or the cable.
Keep them away from your work area.
 Make your workshop childproof.
 Wear suitable work clothes! Do not wear loose clothing or jewellery as they might
get caught in moving parts and cause severe accidents! Wear a hair net if you have
long hair.
 Use personal safety equipment: ear protectors, safety goggles, when working on
dusty jobs.
 Never leave the machine running unattended! Before leaving the working area
switch the machine off and wait until the saw band stops.
 Always disconnect the machine prior to any actions performed at the machine.
 Avoid unintentional starting
 Each time you work with an electrically operated sawing apparatus, caution is
advised! There is a risk of electric shock, fire, cutting injury;
 Protect the machine from dampness (causing a short circuit)
 Use power tools and machines never in the vicinity of flammable liquids and gases
(danger of explosion)
 Check the cable regularly for damage
 Protect the cable from heat, oil and sharp edges.
 Avoid body contact with earthed
 Use appropriate holding device when sawing logs
 The upper blade guide to keep as close to the workpiece
 Attach the fence to the lower half of the table for inclined table
 Workpieces while working safely hold and guide
 Remove the sawed-off or jammed workpieces only at standstill of the saw blade
 Make sure that no excessive concentration of dust is produced. Use suitable dust
extraction equipment!
 Remove before editing foreign matter (nails, screws) from the workpiece
 For straight cuts against the rip fence push stick should be used
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
31
HBS 300J