Changing The Band Saw Blade (Fig.16); Changing The Rubber Tires On The Blade Pulleys (Fig. 17); Changing The Table Insert (Fig. 18); Disposal - HOLZMANN MASCHINEN HBS 300J User Manual

18.3

Changing the band saw blade (Fig.16)

Wear gloves when handling with saw blades!
Before changing the blade, check that the machine is swiched
off and disconet from the power suply
ATTENTION: Take care to install the saw band correctly!
Check the direction of the teething
 Move the blade guide (11) into a position approximately half way between the table (15) and the
machine frame (24).
 Undo the fasteners (13) and open the side cover (12).
 Remove the chain bar (2).
 Turn the tightening screw (9) anti-clockwise to remove the tension from the blade (25).
 Remove the blade (25) from the blade pulleys (7,8) and take out through the slot in the table (15).
 Fit the new blade (25), aligned centrally on the blade pulleys (7,8).
 The teeth of the blade (25) must point downwards in the direction of the table.
 Tension the blade (25) (see 7.2)
 Close the side cover (12) again.
 Mount the web panel (4) again.

18.4 Changing the rubber tires on the blade pulleys (Fig. 17)

After a certain time the rubber tires (3) on the blade pulleys (7,8) will get worn by the sharp teeth of
the blades and must be replaced.
 Open the side cover (12).
 Remove the blade (25) (see 7.7)
 Lift the edge of the tire (3) with a small screwdriver (f) and remove it from the blade pulley (8).
 Repeat for the lower blade pulley (7).
 Fit the new rubber tire (3), mount the blade (25) and close the side cover (12) again.

18.5 Changing the table insert (Fig. 18)

To prevent increased likelihood of injury the table insert (17) should be changed whenever it is worn
or damaged.
 Dismantle the saw table (15) (see 7.2).
 Push out the worn table insert (17).
 Fit the replacement table insert by following the above in reverse.

18.6 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old
HOLZMANN MASCHINEN GmbH
W A R N I N G
HIGHEST RISK OF CUTTING INJURY!
www.holzmann-maschinen.at
MAINTENANCE
39
HBS 300J