Network & Time Settings - Honeywell X-618 Commissioning Manual

Figure 11 Basic Property – Contact Outputs Window
2. Enable or disable the required contact output ports as necessary, and set the corresponding
port descriptions.
3. Click the OK button to finish configuring the contact output settings.
Network & Time Settings
4. Click the Network & Time button in the subsystem area on the right side of the window, as
shown in Figure 6. The Network & Time Settings window is displayed, as show in Figure 12.
Figure 12 Network & Time Settings Window
5. Set the DCS network parameters, including the IP address, Subnet mask, and Default
gateway, as necessary. The IP address must meet the network requirements and be unique.
6. After configuring the network settings, if uploading the network parameters to the system
devices is necessary, the PC on which the software has been installed directly to the system
devices without connecting the computer to the X-618 network, and then click the Set button.
The default IP address is 192.168.2.200. If the upload of settings to the devices failed, or if the
13