Contact Output Settings - Honeywell X-618 Commissioning Manual

Figure 9 Basic Property – Fault Monitoring Settings
2. Set the Check Enable options as necessary.
3. Set the Line impendence percentages.
To set the line impendence percentages, follow the steps below:
a. Double-click the row corresponding to the zone line impedance percentages that needs to
be set. The Edit Line Impendence Percent window is displayed, as shown in Figure 10.
Figure 10 Edit Line Impendence Percent Window
b. Enable or disable the line impendence percentage. If Enable is selected, the Minimum
Line Impendence and Maximum Line Impendence values must be set.
c. Click the OK button to finish configuring the line impendence percentage values.
4. Set the Line check interval value.
5. Click the OK button to finish configuring the fault monitoring settings.

Contact Output Settings

The purpose of the contact output settings is mainly for enabling the eight dry contact ports.
The steps for configuring the dry contact output ports are as follows:
1. Click the Contact Output tab in the Basic Property window, as shown in Figure 7. The
Contact Outputs page is displayed, as shown in Figure 11.
12