Dcs Basic Property Settings; Device Parameter Settings; Ntp Settings - Honeywell X-618 Commissioning Manual

DCS Basic Property Settings

The basic property setting function allows users to configure the following settings:


Device Parameter Settings



NTP Settings


Fault Monitoring Settings

Contact Output Settings
Device Parameter Settings
The device ID, device description, device type, and work mode for the DCS can be set under this
tab.
To set the DCS device parameters, perform the following steps:
1. Click Basic Property in the subsystem area on the right side of the window, as shown in
Figure 6. The Basic Property settings page is displayed, as shown in Figure 7.
Figure 7 Basic Property Settings Window
2. Set the Device ID, Device description, Device Type, and Work Mode.
The Work Mode can be set to one of the following:

The A Mode: Power Matrix Direct setting configures a system consisting of power
amplifiers and speaker zones. The size of the matrix is determined by the actual number
of the amplifiers and zones. Any zone in the matrix can select any audio source.

The B Mode: Amplifier Direct Driver setting configures a system that drives one or more
zones through each audio channel power amplifier, which can improve the output power
of each zone. Each zone corresponding to the same amplifier broadcasts the same
content.
3. Click OK to complete configuring the settings.
NTP Settings
The steps for configuring the NTP settings are as follows:
10